Control panel Part #1
The panel has been cleaned.
A rectangular breach has to be cut out to make room for the new layout.
The breach has been made, it's time for a first layer of primer.
Those are the new 4/8 way joysticks and buttons I've ordered at http://www.ultimarc.com.
Right now, I have to design a new top plate (MDF 1cm thick) for the panel.
A pic of the Mini-Pac along with the wires and USB cable, also from Ultimarc.
The wires are quite short: that could be a problem if the interface is not placed in the middle of the panel.
This is the new MDF top plate, ready to be painted.
The front plate is now mounted on the panel: that will do!
A rectangular breach has to be cut out to make room for the new layout.
The breach has been made, it's time for a first layer of primer.
Those are the new 4/8 way joysticks and buttons I've ordered at http://www.ultimarc.com.
Right now, I have to design a new top plate (MDF 1cm thick) for the panel.
A pic of the Mini-Pac along with the wires and USB cable, also from Ultimarc.
The wires are quite short: that could be a problem if the interface is not placed in the middle of the panel.
This is the new MDF top plate, ready to be painted.
The front plate is now mounted on the panel: that will do!
posted by Denus at 4:27 PM
0 Comments:
Post a Comment
Links to this post:
Create a Link
<< Home